Connect all actuators to cabling using female bullet connectors and then connect power to controller. Then run 2 wires (3mm 10amp) from the controller white & white/black to the first actuator and then loop wires to all other actuators, using loom tube and stick on mounts to secure wiring inside canopy. Now referring to wiring diagram supplied, run a 15 amp cable to the controller from a positive power source.
Mount controller anywhere in cabin (this is important for ease of accessibility in the event of unforseen failure). The hole in the bracket may need to be enlarged to ensure the pin moves freely with the window in the closed position, the bracket may also have to be bent in or out to ensure the pin engages with the bracket when locked and clears the bracket when unlocked. Place the spacer under the actuator with a dob of silicone on each side and then secure the actuator to the window frame using 2 of the 8g x 16 (silver) screws. Now push the pin in to make sure the pin clears the bracket so the window can be opened. Make sure the rear window is fully closed, hold an actuator onto the inside of the window frame with the pin extended lining up the actuator pin to the centre of the hole in the window bracket and the shoulder on the pin touching the bracket. With bracket now installed use 2 pairs of pliers to twist the bracket so it is parallel to the window frame so the actuator pin enters the bracket at right angles. Replace the 2 bolts, nuts, screw and cover over latch. Remove the cover from over the latch on the right hand side of the rear window, remove the strut from the window bracket, remove the screw holding the latch to the cover and then undo the 2 nuts holding the latch to the window, take out the 2 bolts and insert the right hand window bracket on top of the rubber. Repeat steps 1 & 2 for other side window locking positions (next to handles). The bracket can also be bent up or down to ensure actuator pin engages with the bracket when locked and clears the bracket when unlocked The hole in the bracket may need to be enlarged to ensure that the pin moves freely with the window handle in the closed position, this can be done by using a file to make the hole larger. Secure the actuator to the window frame using 2 of the 8g x 12 screws. Now push the pin of the actuator fully down to make sure top of pin clears the bracket so window can be opened. Where the window bracket is now installed place an actuator on the inside of the window frame with the pin extended upwards and line up the pin to the centre of the hole in the bracket and the shoulder on the pin to the underside of the bracket. Push one of the black plastic caps over the outside end of the bracket When the bottom of the bracket is touching the window, push double sided tape onto the window to secure bracket. 
(it is recommended to mark the positions of all the brackets and then clean all positions so wipe does not dry out) Then peel the plastic from double sided tape on bracket and slide the bracket over bottom of the window (without the tape touching the window).
Select location for window bracket (close to handle but leave enough room so as not to interfere with movement of the handle, and making allowance for the protection bracket to be installed) Use VHB wipe to clean the window where bracket is to be fitted.
Installation:(note if you are unsure of these steps please refer to the picture gallery at – most steps are shown):Side window handles must be in the closed position and the rear window must be fully shut for the locking kit to work.
0 kommentar(er)
